Masterbuilt error codes usually point to temperature probes, meat probes, fan issues, ignition problems, or door switches. Try a reset first. If the code returns, a replacement part is usually needed.
Quick Fix Table
| Code | Meaning | Quick Fix | Common Replacement Part |
|---|---|---|---|
| Err1 / EEA1 / EAA1 | Ambient temp probe open, disconnected, or faulty | Unplug 10 min, reseat probe, clean tip | Ambient temperature probe |
| Err2 | Meat probe missing or defective | Plug into correct port, test/reseat probe | Meat probe / cabinet probe |
| Err3 | Overheat or fan not running | Cool down, clean fan, close hopper lid | Fan / hopper lid switch |
| Err4 | Charcoal failed to ignite or temp too low | Clear ash, check fire starter, open airflow slides, close doors | Igniter / fan / door switches |
| OPEN | Door or lid safety switch thinks it is open | Close all doors and lids, check switches | Door/lid safety switch |
| Err0 | Wiring or cabinet probe issue on some electric models | Check probe wiring and connections | Cabinet probe / wiring harness |
How to Reset Masterbuilt Error Codes
-
Turn off and unplug the smoker.
-
Close all doors and lids.
-
Check and clean temperature probes.
-
Reseat all probe and switch connections.
-
Wait 10 minutes.
-
Plug in and restart.
If the same code returns, replace the faulty part.
Model Notes
Gravity Series 560 / 800 / 1050
-
Err1: Ambient temperature probe
-
Err3: Overheating or fan/switch issue
-
Err4: Did not reach temp fast enough
-
Check ash buildup, airflow slides, hopper lid, and ash door switches
Electric Masterbuilt Models
-
Err1 / Err2 at power-on: Often temperature sensor or heating element connection
-
Err2: Meat probe or internal cabinet probe
-
Err0: Cabinet probe wiring issue
Common Parts That Fix Masterbuilt Error Codes
Ambient temperature probe | Meat probe | Fan | Hopper lid switch | Ash door switch | Igniter | Controller board | Heating element | Wiring harness | etc
FAQ
What does Err1 mean on a Masterbuilt?
Usually the ambient temperature probe is disconnected, too cold, or faulty.
How do I reset my Masterbuilt smoker?
Unplug it for 10 minutes, close all doors, check probe connections, then restart.
Why does my Masterbuilt say OPEN when the door is closed?
The door/lid safety switch is likely misaligned, dirty, or faulty.
Can I bypass a Masterbuilt safety switch?
No. Replace the faulty switch with a compatible part.
Need Masterbuilt Replacement Parts?
If a reset does not clear the code, replace the failed probe, fan, switch, igniter, or controller. Always check your model and serial plate before ordering.
👉 Shop replacement parts today.
Masterbuilt is a trademark of its respective owner. We are not affiliated with Masterbuilt. Always follow your owner’s manual and safety instructions.