Free Shipping From $19.99 For US

Masterbuilt Error Codes and Fixes: Quick Guide

Masterbuilt error codes usually point to temperature probes, meat probes, fan issues, ignition problems, or door switches . Try a reset first. If the code returns, a replacement part is usually needed.

Quick Fix Table



Code Meaning Quick Fix Common Replacement Part
Err1 / EEA1 / EAA1 Ambient temp probe open, disconnected, or faulty Unplug 10 min, reseat probe, clean tip Ambient temperature probe
Err2 Meat probe missing or defective Plug into correct port, test/reseat probe Meat probe / cabinet probe
Err3 Overheat or fan not running Cool down, clean fan, close hopper lid Fan / hopper lid switch
Err4 Charcoal failed to ignite or temp too low Clear ash, check fire starter, open airflow slides, close doors Igniter / fan / door switches
OPEN Door or lid safety switch thinks it is open Close all doors and lids, check switches Door/lid safety switch
Err0 Wiring or cabinet probe issue on some electric models Check probe wiring and connections Cabinet probe / wiring harness

How to Reset Masterbuilt Error Codes

  1. Turn off and unplug the smoker.

  2. Close all doors and lids.

  3. Check and clean temperature probes.

  4. Reseat all probe and switch connections.

  5. Wait 10 minutes.

  6. Plug in and restart.

If the same code returns, replace the faulty part.

Model Notes

Gravity Series 560 / 800 / 1050

  • Err1: Ambient temperature probe

  • Err3: Overheating or fan/switch issue

  • Err4: Did not reach temp fast enough

  • Check ash buildup, airflow slides, hopper lid, and ash door switches

Electric Masterbuilt Models

  • Err1 / Err2 at power-on: Often temperature sensor or heating element connection

  • Err2: Meat probe or internal cabinet probe

  • Err0: Cabinet probe wiring issue

Common Parts That Fix Masterbuilt Error Codes

Ambient temperature probe | Meat probe | Fan | Hopper lid switch | Ash door switch | Igniter | Controller board | Heating element | Wiring harness | etc

FAQ

What does Err1 mean on a Masterbuilt?
Usually the ambient temperature probe is disconnected, too cold, or faulty.

How do I reset my Masterbuilt smoker?
Unplug it for 10 minutes, close all doors, check probe connections, then restart.

Why does my Masterbuilt say OPEN when the door is closed?
The door/lid safety switch is likely misaligned, dirty, or faulty.

Can I bypass a Masterbuilt safety switch?
No. Replace the faulty switch with a compatible part.

Need Masterbuilt Replacement Parts?

If a reset does not clear the code, replace the failed probe, fan, switch, igniter, or controller. Always check your model and serial plate before ordering.

👉 Shop replacement parts today.

Masterbuilt is a trademark of its respective owner. We are not affiliated with Masterbuilt. Always follow your owner’s manual and safety instructions.

Go to full site